Williams 3501922A Manuel d'instructions télécharger pdf (Page 3)

A Word From The Manufacturer

Dear Customer,

Toset up our furnace assembly procedures, several hundred quality assurance, safety audit and design performance

tests have been conducted according to the standards provided by the American National Standards Institute, the Depart-

ment of Energy and our certification agency -- the American Gas Association Laboratories.

This was done to assure you of receiving the best value and most reliable appliance of its type available today.

We are confident that your Williams furnace can provide you years of low cost, efficient, heating comfort.

Thank you for purchasing a Williams furnace.

Sincerely,

Employees of Williams Furnace Company

Introduction

Please read our instructions before you install and use your heater. This will help you obtain the full value from this

heater. It could help you avoid needless service costs, if the answer to the problem is found within this instruction

manual.

Basic Description

Always consult your local heating or plumbing inspec-

tor, building department or gas utility company

regarding regulations, codes or ordinances which

apply to the installation of a vented room heater.

The heat exchanger is built of heavy gauge steel treat-

ed for corrosion resistance. The heater cabinet is also

constructed of heavy gauge steel and has an enamel

paint finish.

No electric power is required unless furnace is

equipped with an optional blower accessory.

The efficiency rating of this appliance is a product ther-

mal efficiency rating determined under continuous

operating conditions and was determined independent

of any installed system.

Warmed air is discharged into the room in which the

heater is located.

The heater contains a single multi-slot gas burner.

Combustion air is drawn in from the room where the

heater is located and is vented out of the heater verti-

cally through vent piping to a roof vent top. (Vent

equipment is not supplied with heater).

The heater controls are located behind a access door

on the side of the heater. All models are equipped with

AGA listed gas valves and pilots.

NOTE, ALL MODELS:

This appliance is equipped with a vent safety shutoff

system, designed to protect against improper venting

of combustion products. Operation of this room

heater when not connected to a properly installed and

maintained venting system or tampering with the vent

safety shutoff system can result in carbon monoxide

(CO) poisoning and possible death.

Helpful Installation Information

The following booklets will help you in making the

installation:

ANSIINFPA 70, or current edition "National Electrical

Code:' In Canada: CSA C22.1 Canadian Electrical

Code.

American National Standard Z223.1 or current edition

"National Fuel Gas Code:'

Obtain from--Amedcan National Standards Institute,Inc.,

1430 Broadway, New York, N.Y. 10018. In Canada: CAN/

CGA B149.

--3--

1 2 3 4 5 6 7 8 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Williams 3501922A Manuel d'instructions Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffages d'appoint Williams 3501922A