Williams 3501922A Manuel d'instructions télécharger pdf (Page 15)

INSTALLATION & OPERATING INSTRUCTION

2101 BLOWER ACCESSORY

(AVAILABLE ONLY FOR 350, 500, & 650 MODEL SERIES)

WARNING

NOTE:All electrical work must be conform to your local

codes and ordinances or in their absence, with

National Electrical Code,ANSI/NFPA 70. If

you are not famnlar with wtdng codes In general,

havea competentdectrlclando this job. in CANADA

CANADIANELECTRICALCODEC22.1.

DANGEROF PROPERTYDAMAGE,BODILYINJURY

OR DEATH.]URN OFFElECTRiCALPOWERSUPPLY

AT DISCONNECTSWITCH,FUSEBOX OR SERVICE

PANEL BEFOREREMOVINGOR WORKINGFAN.

L (EXAMPLE I)

650 SERIES

500 SERIES

EXAMPLE 2)

350 SERIES

FIG,1 .A

A. BLOWER ACCESSORY KIT INSTALLATION

WARNING: This appliance

is equipped with a three-

prong (grounding) plug for

/our protection against

shock hazard and should

be plugged directly into a

)roperly grounded three-

prong receptacle.

DO NOT CUT OR REMOVE

THE PRONG. Oil motor every

6 months with a few drops

of SAE 20 motor oil.

A: MOTOR & BLOWER

B: GAS VALVE

C: CONDUIT

D: CONTROL ROD

E: CABLE CLAMP

F: CORD & PLUG

G: CONTROL BOX

H: TEMPERATURE DIAL

J: BLOWER SPEED

SELECT SWITCH

K: FAN LIMIT SWITCH

L: SENSOR MOUNTING

BRACKET

M: SPILL SWITCH

N: COUPLING

This accessory is installed on heater back and will increase circulation of warm air

through heated space. A 115V 60Hz outlet adjacent to the furnace is required,

NOTE: WALl THERMOSTAT MODELS ONLY

Control Rod (D), Temperature Dial (H), and Coupling (N) are not used or supplied

with Wall Thermostat Models. Wall Thermostat Models utilize a mlllivolt Thermostat

for Temperature Control. For Wall Thermostat Model installations, disregard STEPS 3

and STEP 4 on these instructions.

INSTALL AS FOLLOWS:

STEP 1. Choose a location for heater installation near 115v electrical outlet (within

5 feet to rear of heater.)

STEP 2. Place motor & blower (A) on heater floor, securing with (4) screws as shown

in RG.1. Also place control box (G) near the top of furnace back, securing with

(21 screws as shown In RG.1.

(NOTE: Install this klt by using the holes in cabinet only.)

STEP 5. Attach temperature dlal (H) to hole free end of control rod (D). Tighten set

screw and set assernby aside for now.

--15--

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Commentaires sur ces manuels

Pas de commentaire

Williams 3501922A Manuel d'instructions Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffages d'appoint Williams 3501922A